Table of Contents
Advertisement
Preparation
Signal Connections
Video signals
Camera control unit
LINE OUT
MAIN
POWER
DVI IN
IN
FOR SERVICE
DVI OUT
AC IN
Digital video signal
DVI
Monitor
The video signal for input is selected using INPUT SELECT from the INPUT SELECT MENU screen.
The audio signals for input are selected using INPUT SELECT from the INPUT SELECT MENU screen.
When either DVI, LINE or Y/C is set for INPUT SELECT, the analog audio signals from the AUDIO IN terminals will be selected
for input.
When DV is set for INPUT SELECT, the DV audio signals from the DV IN/OUT terminal will be selected for input.
Use the following cable as the DV cable.
VC-VDV204 (2m, 4P-4P) from JVC
VC-VDV206 (2m, 4P-6P) from JVC
20
Monitor
Camera
Analog video signal
Y/C OUT
VIDEO
AUDIO
LINE
INPUT
CH1
LEVEL
IN
OUT
+4dB
-8dB
Y/C
Y/C
OUT
CH2
REMOTE
FOOT SW
DV IN/OUT
1
2
USB
USB
FOOT SW
Keyboard
FOOT SW
Power Connections
Connect the Power cord (included) to the DVD recorder.
MAIN
MAIN POWER switch
Power cord
(included)
AC
OPERATE indicator
OPERATE
OPERATE button
AUDIO
CH1
CH2
PHONES
REV
Turning the Power On
While in Operate Off mode (i.e., the OPERATE indicator
is lit up in orange), press the OPERATE button.
The power will turn on, the color of the OPERATE indicator
will change to green, and the DVD recorder will become
ready for use. (Operate On mode)
Note
A period of 45 seconds may pass before the DVD recorder
adopts Operate On mode as it prepares for operation.
A small amount of current will be required by the DVD
recorder when in Operate Off mode.
1.
Connect the Power cord (included) to the DVD
recorder's AC IN terminal.
POWER
2.
Connect the power cord (included) into an
electrical outlet.
3.
Set the MAIN POWER switch to ON.
Power will be supplied to the DVD recorder and the
OPERATE indicator will be lit up in green. (Operate On
mode)
AC IN
The AC IN MODE item on the SYSTEM MENU (2/2)
screen can be used to specify whether to start up in the
Operate ON or OFF mode when the power switch is turned
ON. (☞ Page 65)
CAUTION
Always use the AC cord provided with the DVD recorder.
The use of other power cord should be avoided.
Do not turn the power off during recording or playback.
In the case of DVD-R / DVD+R discs, failure to observe
this precaution will result in the discs becoming unusable.
In the case of DVD-RW / DVD+RW discs, it will be
necessary to erase all data from the disc and to start
recording again from the beginning.
Turning the Power Off
Stop the DVD recorder.
(It is recommended that you eject the disc at this time.)
1.
Press the OPERATE button.
The DVD recorder will adopt Operate Off mode and the
color of the OPERATE indicator will change to orange.
2.
If the DVD recorder will not be used for an extended
period of time, set the MAIN POWER switch to OFF.
When disconnecting the power cord, remove the power
cord from the electrical outlet first.
Notes
Pressing the OPERATE button will have no effect in
Recording mode or Recording Pause mode.
Pressing this button also has no effect during finalizing
and erasing.
21
Advertisement
Table of Contents
