Event Messages; Alarm Messages - Stryker 240-020-505 Instructions Manual

LCD Display and On-Screen Content
Event Messages ( Only the VIDEO LINE OUT or Y/C OUT terminal)
Event messages are displayed on the DVD recorder's LCD display and on the monitor when incorrect operations are attempted.
These messages will remain on-screen for approximately 3 seconds.
Monitor screen
000 min

Event messages:

Displayed when
DISPLAY from
TITLE FULL
the
MENU screen is
set to ON.
REC
04/05/04 TITLE 01 0:11:22
11:20:00 CHAPTER 01 0:11:22
LCD display
Monitor message
message
INVALID TV INVALId TV A signal of an invalid format has been input.
Alternatively, an attempt has been made to play a disc containing signals of an invalid
format.
TITLE FULL TITLE FULL Recording was attempted on a disc already containing 99 titles.
INDEX FULL INdEX FULL An attempt was made to add a index to a title already containing 99 index.
CHAPTER FULL CHAP FULL An attempt was made to add a chapter to a title already containing 99 chapter.
NOT FINALIZE NoT FINAL An attempt was made to eject a disc before it was finalized.
———— A L-xxxx-R Set value is displayed when changing the recording level of analog audio.
———— d L-xxxx-R Set value is displayed when changing the recording level of digital audio.
OPE LOCK oPE LoCK This is displayed when buttons on this unit are operated while the Operation Lock is
activated. Operation Lock can be canceled by setting the OPERATION LOCK item
on the SYSTEM MENU (2/2) screen to OFF.
DAILY RECORDING dAILY rEC This is displayed when buttons on this unit are operated during DAILY RECORDING.
(☞ Page 42)
18
LCD display
DOLBYDIGITAL
LPCM MPEG
DISPLAY Event message
Description
Alarm Messages ( Only the VIDEO LINE OUT or Y/C OUT terminal)
Alarm messages are displayed on the DVD recorder's LCD display and on the monitor when the recorder cannot obey a command.
These messages will remain on-screen until the next operation is carried out.
Monitor screen
000 min

Alarm messages:

Displayed when
DISPLAY from the
REC INHIBIT
DISPLAY MENU
screen is set to
ON.
REC
04/05/04 TITLE 01 0:11:22
11:20:00 CHAPTER 01 0:11:22
LCD display
Monitor message
message
INVALID DISC INVALId dISC The current disc is not a DVD-R / DVD-RW or DVD+R / DVD+RW.
NOT SUPPORT NoT SUPPoRT A disc recorded using a different DVD recorder was inserted or played.
DISC
REC INHIBIT REC INH Recording was attempted using a disc on which no more data can be recorded.
The current disc is a non-finalized disc to which no more data can be recorded.
COPY INHIBIT CoPY INH Recording of a copy-protected signal was attempted.
DISC FULL dISC FULL All remaining space on the disc is used up during recording.
CELL OVER CELL oVER The number of cells for a single title exceeded 255.
This will be displayed when the recording time for a single title is exceeded as a
result of setting ENCODE QUALITY to a low quality, recording content with little
movement, or other similar factors.
OVERHEATING! oVERHEATING Displayed when the internal temperature of the set rises due to fan malfunction, etc.
In this case, immediately turn off the power and discontinue use. The power will
automatically shut down in about 20 minutes after the OVERHEATING display.
INVALID SYNC INVALId SYNC This is displayed if recording is discontinued when signals are interrupted and out of
sync during recording.
———— ERRoR This is displayed when playback or recording is stopped due to dirt or damage on the
disc. In this case, either clean the disc or replace it.
FAN STOP FAN SToP This is displayed when the fan stops.
CAUTION
If alarm messages such as "INVALID DISC" are displayed several times when a disc recorded using this DVD recorder or a
blank disk is inserted, there is a possibility that the disc itself has been damaged. In such a case, the damaged disc should be
replaced with a new one.
If the alarm messages continue to appear after replacing the disc, the problem may lie within the DVD recorder, and in such a
case, you are recommended to contact either the store where this DVD recorder was purchased or your authorized dealer.
LCD display
DOLBYDIGITAL
LPCM MPEG
Alarm message
Description
19