Getting Started; Before Installation; Checking The Supplied Accessories; Putting Batteries In The Remote Control - JVC XV-NK58SL Instructions Manual

Getting started

Before installation

General Precautions
• DO NOT insert any metal object into the unit.
• DO NOT disassemble the unit or remove screws, covers, or cabinet.
• DO NOT expose the unit to rain or moisture.
Locations
• Install the unit in a location that is level and protected from moisture.
• The temperature around the unit must be between –5˚C and 35˚C.
• Make sure there is good ventilation around the unit. Poor ventilation
could cause overheating and damage the unit.
Handling the unit
• DO NOT touch the power cord with wet hands.
• DO NOT pull on the power cord to unplug the cord. When
unplugging the cord, always grasp the plug so as not to damage the
cord.
• Keep the power cord away from the connecting cords and the
antenna. The power cord may cause noise or screen interference. It
is recommended to use a coaxial cable for antenna connection,
since it is well-shielded against interference.
• When a power failure occurs, or when you unplug the power cord,
the preset settings such as preset FM or AM channels and sound
adjustments may be erased in a few days.

Checking the supplied accessories

Check to be sure you have all of the following supplied accessories.
The number in parentheses indicates the quantity of each piece
supplied.
• Remote control (1)
• Batteries (2)
• AM loop antenna (1)
• FM antenna (1)
• Digital coaxial cord (1)
• AC plug adaptor (1)
If anything is missing, contact your dealer immediately.
4

Putting batteries in the remote control

Before using the remote control, put two supplied batteries first.
1
Press and slide the
buttery cover on the back
of the remote control.
2
Insert batteries.
Make sure to match the polarity:
(+) to (+) and (–) to (–).
3
Replace the cover.
If the range or effectiveness of the remote control decreases, replace
the batteries. Use two R6P(SUM-3)/AA(15F) type dry-cell batteries.
• Supplied butteries are for initial setup. Replace for continued use.
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
• Place batteries in the remote control so they match the polarity:
(+) to (+) and (–) to (–).
• Use the correct type of batteries. Batteries that look similar may
differ in voltage.
• Always replace both batteries at the same time.
• Do not expose batteries to heat or flame.
When using the remote control, aim the remote control directly at the
remote sensor on the front panel.

Setting the voltage selector

Before connections, always do the following first if necessary.
Select the correct voltage in VOLTAGE SELECTOR on the rear of the
receiver by using a screw driver. Check to be sure if the voltage mark
is set to the voltage for your area where this unit plugs in.
VOLTAGE SELECTOR
220V
Voltage mark
230 -
240V
Remote sensor
110V
127V