Connecting The Fm And Am Antennas - JVC XV-NK58SL Instructions Manual

Getting started

Connecting the FM and AM antennas

If FM reception is poor, connect
outdoor FM antenna (not supplied).
FM antenna (supplied)
AM antenna connection
Connect the AM loop antenna supplied to the AM LOOP terminals.
Connect the white cord to the AM EXT terminal, and the black cord to
H terminal.
Turn the loop until you have the best reception.
• If the reception is poor, connect an outdoor single vinyl-covered
wire (not supplied) to the AM EXT terminal. Keep the AM loop
antenna connected.
FM antenna connection
Connect the FM antenna supplied to the FM 75 Ω COAXIAL terminal
as temporary measure.
Extend the supplied FM antenna horizontally.
• If the reception is poor, connect an outdoor FM antenna (not
supplied). Before attaching a 75 Ω coaxial cable with a connector
(IEC or DIN 45325), disconnect the supplied FM antenna.
6
If AM reception is poor, connect an outdoor single vinyl-
covered wire (not supplied).
Snap the tabs on the loop
into the slots of the base to
assemble the AM loop
antenna.
RX-ES1SL
NOTES
• If the AM loop antenna wire is covered with vinyl,
remove the vinyl while twisting it as shown on the
right.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord.
This could cause poor reception.
AM loop antenna
(supplied)