Table of Contents
Advertisement
18
UNITIZED TRANSAXLE: 800/810 GASOLINE VEHICLES
NOTE: Place the blocks so they will support the engine when the transaxle is detached and moved away
from the engine.
16. Remove the drive belt.
16.1. Grasp belt midway between drive and driven clutch and pull up on belt to force the driven clutch
sheaves apart. Roll the belt counterclockwise while pulling it off driven clutch (Figure 18-29,
Page 18-12).
Figure 18-28 Position Powertrain
17. Remove the driven clutch retaining bolt and remove the driven clutch from the unitized transaxle
(Figure 18-30, Page 18-12).
18. Loosen, but do not remove, the governor arm retaining bolt (1) (Figure 18-31, Page 18-12). Remove the
governor arm from the shaft. Do not disconnect cables.
Figure 18-30 Driven Clutch
19. Remove screws (1) securing the governor cable bracket to transaxle (Figure 18-32, Page 18-13).
Page 18-12
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
ENGINE
PAN
APPROX. 6 INCH
WOODEN BLOCKS
RETAINING BOLT
DRIVEN
CLUTCH
DRIVE CLUTCH
Figure 18-29 Remove Drive Belt
Figure 18-31 Governor Arm
Unitized Transaxle Removal
1
Advertisement
Table of Contents
Troubleshooting
