Drive Belt Installation; Drive Clutch - Club Car FE290 Maintenance Service Supplement

17
TORQUE CONVERTER

DRIVE BELT INSTALLATION

1. Position the new belt on the drive clutch, then start the belt over the top of the driven clutch.
2. With the belt started onto the driven clutch, rotate the driven clutch counterclockwise and roll the belt
over the driven clutch sheaves and onto the clutch.
Use Club Car clutch holder
while tightening or loosening drive
clutch retaining bolt.
CLUTCH HOLDER
THREE BOSSES
IN GRAY
Figure 17-3 Loosen Retaining Bolt

DRIVE CLUTCH

Read DANGER and WARNING on page 17-1.
CAUTION
• BE VERY CAREFUL WHEN HANDLING THE CLUTCHES. A CLUTCH THAT HAS BEEN
DROPPED WILL NOT BE PROPERLY BALANCED. IF EITHER CLUTCH IS DROPPED, ASSUME
THAT IT IS DAMAGED AND REPLACE IT.
Page 17-4 2000 FE290 Gasoline Vehicle Maintenance and Service Supplement
DRIVE CLUTCH
RETAINING BOLT
Hook clutch holder
on boss of pully
located behind drive
clutch...push down
on adjacent
boss with holder.
VEHICLE BODY
REMOVED FOR
CLARITY
DRIVEN
CLUTCH
DRIVE CLUTCH
Insert drive clutch
puller into drive
clutch, then tighten
puller to remove
hub.
DRIVE CLUTCH PULLER
PART NO. 1014496)
Figure 17-4 Drive Clutch Removal
Drive Clutch
(CLUB CAR