How To Open The Service Menu, Do Operations On The Menu - Furuno FM-8900S Installation Manual

4. INITIAL SETTINGS
5. If applicable, enter the ATIS ID like how you entered the MMSI.
Note: You can re-enter the MMSI/ATIS ID if it is wrong. Select the applicable
push the CH knob. You are asked if it is OK to clear the number. Select [Yes] then push the
CH knob. Select the number location then push the CH knob. Reenter the number.
6. Turn off the transceiver unit.
7. Do one of the following according to the action taken at step 1 to write the MMSI (and ATIS
ID if applicable) to the memory.
Junction box: Restore the jumper block to its original position (connect jumper block to pins
1 and 2) and close the junction box.
Transceiver unit: Remove the connector.
Note: If you do not restore the jumper block to its original position or remove the shorting link, the
message "HARDWARE KEY" appears at the top-left corner of the standby screen.
4.2 How to Open the Service Menu, Do Operations
on the Menu
1. Press the MENU key to open the menu.
2. Enter the password to show the [SERVICE] menu.
3. Rotate the CH knob to select a menu then push the knob.
4. Rotate the CH knob to select a menu item then push the knob.
5. Rotate the CH knob to select an option (or set numeric value) then push the knob.
6. Press the CANCEL key to go backward in the menu, or press the MENU key to close the
menu.
22
[CLEAR] then