Furuno FM-8900S Installation Manual page 25

3. Set the transceiver unit to the console upside down. Fasten the transceiver unit to the rack
case as shown below.
Rack case
Spacer
Transceiver
Hex
unit
bolt
Plain
washer
4. Replace the cable attached to the junction box with the cable (55 cm, 37-pin D-sub) supplied
with the console kit. Connect the cable (37-pin D-sub) attached to the junction box to the trans-
ceiver unit.
5. Fasten the junction box to the console and connect it to the transceiver unit.
Insert console
upside down.
Spacer
12P connector
14P connector
10P connector
Connect shield to
screw on chassis.
Fasten cable to
post with two
cable ties.
Replace original cable with cable
assembly DSUB37M-PHX3-L550.
Junction box
3. HOW TO ASSEMBLE THE VHF CONSOLE KIT
Hex bolt
19