Junction Box If-8900 - Furuno FM-8900S Installation Manual

1. HOW TO INSTALL THE EQUIPMENT
1.9

Junction Box IF-8900

The junction box can be mounted on a desktop or bulkhead, and is required to connect the remote
station, wing handset, etc. Put the unit within 3 m of the transceiver unit, because that is the length
of the cable connected between the units.
For the bulkhead mount, it is necessary to cover holes in the bottom of the unit to comply with
the Ingress Protection Rating IPx2. Waterproof seals (Type: OP05-133, Code no.: 001-174-890)
are optionally available for this purpose. Set them to the open holes on the underside of the junc-
tion box as shown below, BEFORE installing the junction box.
Fixing
hole
= Hole where to attach
waterproofing seal
To install the junction box, open the cover and fasten the box with four self-tapping screws (5×20).
Close the cover.
CABLE SLOT SIDE
Card spacer
5
To FM-8900S
Fixing
hole