Charcoal Embers; Vermiculite (Model Gd36 Only); Glowing Embers; Retrofit Kit - Napoleon GD36NTR Installation And Operating Instructions Manual

40
6.5

CHARCOAL EMBERS

Randomly place the charcoal embers along the front and sides of the log support tray in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
6.6

VERMICULITE (MODEL GD36 ONLY)

Sprinkle vermiculite around the charcoal embers.
NOTE: Both charcoal embers and vermiculite are not to be placed on the burner.
6.7

GLOWING EMBERS

Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of the
small logs (#2 & #3). Care should be taken to shred the embers into thin, small irregular pieces as only the ex-
posed edges of the fi bre hairs will glow. The ember material will only glow when exposed to direct fl ame;
however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER
logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and PHAZER
from your Napoleon dealer.
6.8

RETROFIT KIT

Real rocks must not be used in this appliance. Heat will cause them to explode.
6.5.1 Remove all burner media from the unit.
6.5.2 Remove the 2 screws already installed in the
fi rebox and secure the rock support bracket
along the back of the fi rebox.
NOTE: When the porcelain panels are installed,
the rock support bracket is secured over the rear
panel.
6.5.4 Place the large cut out rocks along the edge of
the rock support bracket as shown.
6.9

LOGO PLACEMENT

Remove the backing of the logo supplied and place on the glass viewing door, as
indicated.
W415-0210 / S /03.10.09
(RAK-ROCK ADAPTOR KIT IS NECESSARY WITH THIS KIT).
ROCK SUPPORT
BRACKET
WARNING
!
6.5.3 Move the two rock clusters into position, lining
up the studs located on the burner with the
holes in the bottom or the rocks. Ensure the
clusters are sitting fl at on the burner.
6.5.5 Place the remaining refractory rocks around
the burner as desired, making sure not to
cover any burner ports. (There are no set
locations).
TM
logs available
TM
½"
LOGO
½"