Log Placement - Napoleon GD36NTR Installation And Operating Instructions Manual

6.4

LOG PLACEMENT

logs and glowing embers exclusive to Napoleon Fireplaces, provide a unique and realistic
TM
PHAZER
glowing effect that is different in every installation. Take the time to carefully position the glowing embers for a
maximum glowing effect.
Log colours may vary. During the initial use of the fi replace, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
6.4.2 Move the two small logs (#2 & #3) into
position, lining up the studs located on the
burner with the holes on the bottom of the
logs. Ensure that the small logs sit fl at on the
burner.
6.4.4 Position the base end of the center log (#5)
against the middle grate post with the other
end of the log resting in the pocket of the left
crossover log.
6.4.1 Place the back log (#1) onto the
SIDEVIEW
log support tray and in front of
the tabs. The tabs maintain an air
space between the log and
fi rebox back to facilitate
combustion air fl ow. Ensure that
the back of the log rests against
the brackets on the back wall of
TAB
the fi rebox.
6.4.3 Place the bottom of the left crossover log (#4)
against the left fi rebox side and pulled forward
to the grate.
The top of the log should rest in the pocket on
the back log.
6.4.5 Place the bottom of the right crossover log (#6)
against the right fi rebox side and pulled
forward to the grate. The top of the log should
rest in the pocket provided on the center log
(#5).
39
W415-0210 / S / 03.10.09