Minimum Framing Dimensions - Napoleon GD36NTR Installation And Operating Instructions Manual

Minimum clearance to combustible construction from fi replace and vent surfaces:
Combustible Framing:
-
-
-
Combustible Finishing:
-
-
-
Rear Exit
-
-
Top Exit
-
-
* HORIZONTAL VENT SECTIONS - A minimum clearance of 1" at the bottom and sides and 2" at the top of
the vent pipe on all horizontal runs to combustibles is required. Use fi restop spacer W010-1777 (supplied).
* VERTICAL VENT SECTIONS - A minimum of 1" all around the vent pipe on all vertical runs to combustibles
is required except for clearances in fi replace enclosures. See "MINIMUM ENCLOSURE CLEARANCES" sec-
tion. Use fi restop spacer W500-0096 (not supplied).

5.2.1 MINIMUM FRAMING DIMENSIONS

For top exit applications: Do not build into this area. It must be left clear to provide adequate
clearance for the vent. In this 14" wide area centred along the front of the fi replace, no combustibles
TOP EXIT INSTALLATION
SHOWN
ENCLOSURE
FINISHING
MATERIAL
63"
(TOP EXIT)
42 1 /4"
(REAR EXIT)
14 1 /2"
Combustion protrusions such as mantels and shelves may occur at or after a minimum distance of 2" away
from the side of the fi replace. Thereafter, the depth of any protrusions must be equal to or less than the dis-
tance from the side of the fi replace up to a depth of 6", after which no greater clearance than 6" is required.
This can be considered a side wall with no length boundary.
0" to stand-offs
1" to bottom and sides of the vent pipe*
2" to top of the vent pipe*
0" to rear
0" to front face top and sides
14 1/4" recessed depth
39" to enclosure top from base of the unit
72" to ceiling from base of the unit
48 3/8" to enclosure top from base of the unit
72" to ceiling from base of the unit
TOP
14"
MINIMUM
1 1 /2"
MAX
35 3 /4"
3"
5 1 /2"
36 1 /2"
FIGURE 5.2.1a
WARNING
!
are allowed.
36
3 1 /2"
MAX
OUTSIDE
GAS
CHASE
INLET
LOCATION
14 1
3 /4"
FIGURE 5.2.1b
FIGURE 5.2.1c
1 /2"
36
/2"
1 /2"
36
PROTRUSION
FIGURE 5.2.1d
35
14 1
/2"
INSIDE
CHASE
2"
4"
SIDE
2"
4"
WALL
6"
W415-0210 / S / 03.10.09