Bay Window Mantis Log Set Installation Instructions - Empire Comfort Systems BF28BMN-4 Installation Instructions Manual

Mantis power-vent high-efficiency fireplace
Table of Contents

Advertisement

BAY WINDOW MANTIS LOG SET INSTALLATION INSTRUCTIONS

Log Installation
Positioning of the logs is critical to the safe and clean opera-
tion of this heater. If the logs are not placed in the proper
position, the appliance can soot, and create an unsafe op-
erating condition.
CAUTION
Do not handle these logs with your bare hands! Al-
ways wear gloves to prevent skin irritation. After han-
dling the logs, wash your hands gently with soap and
water.
1. To access the log set parcel, lift off the top panel.
2. Pivot the left and right panels open.
3. Unhook the main door latches located on the right and
left side of the heater, then remove the door.
4. Connect the Rear Left Log (A) and the Rear Right Log
(B) to the pins on the sides of each log. Place the logs
behind the rear burner. The logs should be all the way
to the back of the firebox. See Figure 43.
5. Place the Front Left Log (C) into the groove on (A) Log,
and locate into the left corner of firebox. See Figure
44.
6. Place the Middle Log (D) over the flame sensors that are
located in the middle of the firebox.
7. Locate the Front Right Log (E) in the right front corner
of firebox. The Front Right Log (E) should fit snug into
the corner.
8. Place the Top Left Log (F) onto the pin on (A) Log. The
"legs" of (F) Log will rest on (D) Log. See Figure 45.
9. Place the Top Right Log (G) onto the pin on (B) Log.
The "legs" of (G) Log will rest on (E) Log.
10. Place the door assembly on the heater and secure with
the main door latches that are located on right and left
sides of the heater.
11. Close the left and right panels.
12. The installation of the log set is complete.
13. Verify that the logs are not in contact with the flame sen-
sor. Interference with the flame sensor will effect the
operation.
A
Log Placement
Figure 43
27297-5-0511
B
TOP LEFT LOG (F)
C
Log Placement
Figure 44
F
Log Placement
Figure 45
REAR HOT SURFACE IGNITOR
PLATE - LOG SUPPORT
FRONT HOT SURFACE IGNITOR
Firebox Layout
Figure 46
REAR LEFT LOG (A)
FRONT LEFT LOG (C)
Log Assembly
Figure 47
E
D
G
REAR FLAME SENSOR
REAR BURNER
FRONT FLAME SENSOR
FRONT BURNER
TOP RIGHT LOG (G)
REAR RIGHT LOG (B)
FRONT RIGHT LOG (E)
CENTER LOG (D)
Page 25

Advertisement

Table of Contents
loading

Table of Contents