Using The Shuttlepoint Knob; Deleting A Route - Standard Horizon CPF390i Owner's Manual

4. The SELECT ROUTE popup window will be shown.
5. Move the ShuttlePoint knob to the highlight the desired Route and press [ENT].
6. On the Chart page a circle with a flag is shown on the first leg of the Route and a navigation
line is shown, indicating the GPS Chart Plotter is navigating to the first Waypoint in the
Route.
9.6.1

Using the ShuttlePoint knob

1. On the Chart page move the ShuttlePoint knob until the cursor reaches the starting point
of the Route.
2. Press [GOTO] to start following the Route.
3. Press [CLR] twice to revert to Home mode.
9.7

DELETING A ROUTE

To delete a Route follow the procedure below:
1. Press [MENU], move the ShuttlePoint knob to highlight USER POINTS and press
[ENT].
2. Move the ShuttlePoint knob to highlight ROUTE and press [ENT].
3. Move the ShuttlePoint knob to highlight DELETE and press [ENT] or move the
ShuttlePoint knob to the right.
4. A Warning message appears to confirm. Move the ShuttlePoint knob to highlight YES
and press [ENT]. The Route has been deleted.
An active Route (one that you are navigating to) cannot be deleted until you stop navigating to the
Route.
CP390i and CPF390i
WAAS 3D
Figure 9.6.0 - GOTO ROUTE procedure (1)
Figure 9.6.0a - GOTO ROUTE procedure (2)
WARNING
WAAS 3D
WAAS 3D
Page 81