Table of Contents
Advertisement
Usually the VHF Radio will be connected to the Green and Brown wires. To check to see
if the GPS Chart Plotter is transmitting the sentences:
1. Press [MENU], move the ShuttlePoint knob to highlight NMEA DISPLAY and press
[ENT].
2. Move the ShuttlePoint knob to highlight DATA and press [ENT].
3. Connect the BLUE Wire on the GPS Chart Plotter to the junction of the Brown wire and
the VHF wire. The display should look similar to the following picture.
4. Press [ENT] to freese the data on the display so it is easy to read and understand.
5. Press [ENT] again to receive data again.
6. View data from a device connected to another data port, press the [ZOOM IN].
12.8
NMEA TREND PAGES
The CP390i* and CPF390i have the following NMEA Trend pages.
Trends will be shown for Depth, Temp and Speed (DST521 or DST526 must be connected
to show speed through the water) when a Standard Horizon transducer is connected. To
show Wind trend information the CP390i and CPF390i must be connected to the NMEA
output of a external Wind instrument.
The CP390i must be connected to the Optional FF525 (or FF520) 50/200kHz BLACK BOX FISH
FINDER.
To select a NMEA Trend Page:
1. Press [MENU], move the ShuttlePoint knob to highlight NMEA DISPLAY and press
[ENT].
Page 106
Figure 12.7 - NMEA Display menu
Figure 12.7a - NMEA Data page
NOTE*
CP390i and CPF390i
Advertisement
Table of Contents
