Battery Connections; Nmea Connections - Standard Horizon CPF390i Owner's Manual

Gps chart plotters / fish finder
Hide thumbs Also See for CPF390i:
Table of Contents

Advertisement

2.4.3.1 Connection a VideoCamera, AIS Receiver, VHF and Autopilot
VIDEO
Camera
CP300
The Input and Output baud rate for each port is set using the Advanced
Setup>In/Out Connections menu. For example if Port1 is set for AIS 38400, the
Input and Output both operate at 38400 baud.
2.4.3.2 AIS Setup
The CPF390i has to be set up to be able to receive NMEA information from the AIS receiver.
The GPS Chart Plotter reads the AIS NMEA message VMD, type 1, 2, 3 and 5. Select the
used port and transmission speed by following the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight PORT2 INPUT and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select AIS 38400 and press [ENT] or move the
ShuttlePoint knob to the right.
2.5

BATTERY CONNECTIONS

1. The GPS Chart Plotters are supplied with a fuse and holder. This fuse should be
installed into the Black wire to protect the NMEA Output/Input circuits from possible
damaged.
2. Connect the Red and Black wires from the GPS Chart Plotter to a 12VDC source as
directly as possible.
2.6

NMEA CONNECTIONS

The GPS Chart Plotter can be connected to external devices with NMEA and display
information, examples:
· DSC VHF Radio
· Depth Sounder, Speed Log, Wind Instrument, Autopilot etc.
Page 24
SMART GPS
Antenna
Tee
FF520
Optional
Fish Finder
Transducer
NOTE
Red
No Connection
Black
No Connection
Green
NMEA Common
Blue
Port 4 Input
Brown
Port 4 Output
Gray
Port 5 Input
White
Port 5 Output
Yellow
No Connection
Red
Black
2A
Fuse
Green
NMEA Common
Blue
Port 1 Input
Brown
Port 1 Output
Gray
Port 2 Input
White
Port 2 Output
Yellow
Port 3 Output
CP390i and CPF390i
AIS
Switch
-
+
Battery
10-35Vdc
VHF
PILOT

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp390i

Table of Contents