Fish Symbols; A-Scope; Transducer Setup; Keel Offset - Standard Horizon CPF390i Owner's Manual

17.11.3

Fish Symbols

Controls the graphical representation of underwater-suspended targets.
Echo
Icon + Echo
Icon + Echo + Depth : shown as arches with the Fish icon and relative depth values
Echo + Depth
Icon
Icon + Depth
17.11.4

A-Scope

Shows the real time display of the echo from the bottom.

17.12 TRANSDUCER SETUP

This menu allows you to calibrate the speed through the water, water temperature and the
keel/prop offset of the transducer.
17.12.0

Keel Offset

The keel offset can be set to cause the Fish Finder to display an offset depth below the keel
or the actual water depth from the surface. To setup to show the depth below the keel, enter
a negative depth value or a positive depth to show offset from the transducers face to the
water surface.
17.12.1

Calibrate Water Speed

Used to calibrate the Water Speed readings from the transducer. Adjustment can be made
from -10% to +10%.
17.12.2

Calibrate Water Temp

Used to calibration on the Water Temperature sensor in the transducer.
CP390i and CPF390i
: shown as arches (echoes)
: shown as arches with the Fish icon
: shown depth values
: shown as Fish icons without the arches
: shown as Fish icons and their relative depth values (shown accord-
ingly to currently selected depth unit)
Figure 17.12 - Transducer Setup menu
Page 143