Table of Contents
Advertisement
3.1.0
Power On, Off and ShuttlePoint Knob operation
1. Press and hold [PWR] until the display shows the Start-Up page (see the following
picture). To turn Off, press and hold [PWR] until the display turns Off.
2. When the power is first turned on two pages the start-up page and the Caution pages are
briefly shown before the GPS Status page.
WARNING-LIMITATIONS ON USE
This product, including the C-MAP by Jeppesen charts, is intended to be used only as
an aid to navigation. It should facilitate use of official government charts, not replace
them. Only Official Government Charts and Notices to Mariners contain all the current
information needed for safe navigation. This product's features cannot be relied on as
complete or accurate and may vary depending on location. It is the captain's
responsibility to use official government charts, notices to mariners, caution, sound
judgment and proper navigational skills when operating their boat using this product.
This product supports C-MAP by Jeppesen electronic charts. Their use is subject to a
separate Jeppesen Data License Agreement which can also be found at
www.jeppesen.com, where users may also register to receive regular product safety
information.
The built- in C-MAP by Jeppesen background charts of this product contain a limited
version of chart datasets only for general awareness.
By pressing ENTER, you confirm that you:
1. acknowledge the above warning and accept the limitations of this product and the
C-MAP by Jeppesen charts
2. have read the documentation for this product, including its notes, and the Jeppesen
Data License Agreement, and agree to be bound by the terms of the Jeppesen Data
License Agreement.
The Caution page on the left is shown only if the data C-CARD is over one year old.
3. When the GPS Chart Plotter is first turned on it will take some time for the GPS to acquire
a fix of your position. Look closely at the GPS Status page and you will see satellites and
relative signal strengths of each satellite. After a fix is received the GPS Chart Plotter
will automatically switch to the Chart Page with the ship icon centered on the screen.
CP390i and CPF390i
CPF390i
Figure 3.1.0 - Example of Start-Up page on CPF390i
Figure 3.1.0a - Caution pages
NOTE
IMPORTANT:
The built-in C-MAP by Jeppesen charts are out-of-date, and may be
unsafe for navigation, which could place you and others at risk. You
are encouraged to contact your local dealer or Jeppesen to update the
built-in charts. Register with Jeppesen
(www.jeppesen.com) for real-time product updates and safety notices.
Press ENTER to proceed .
Figure 3.1.0b - Built-In Charts warning pages
GPS Chart Plotter
Software V16.30 00R
This product contains a limited set of built-in C-
MAP by Jeppesen Charts.
Contact your dealer or Jeppesen for upgrade
options. Register with Jeppesen to receive
regular product safety information.
Press ENTER to proceed.
WARNING
Page 33
Advertisement
Table of Contents
