Fujitsu Airstage V series Service Manual page 86

5
Operation setting
Raise
Lower
Press the Start/Stop button or the Master Control button or the Set Temperature button to set the operation.
6
CLOCK ADJUST
Press again the PROGRAM (CLOCK ADJUST) button to comp-
lete the weekly timer setting.
* flashes for 2 seconds.
7
To set up the next timer on the same day.
Then press the ENTER button to proceed to the time setting, and repeat steps from
To set up the timer on another day of the week and another indoor units, repeat steps from
To delete the operating time
NOTES
(1) For HEAT PUMP MODEL, Does not operate according
to the settings for the HEAT timer during the cooling
mode and for the COOL or DRY timer during the heating
mode.
no
display
no setting ON
* *
no
display
AUTO COOL
no setting
* If the "ALL indoor unit" is selected and all of the indoor units are
"COOLING ONLY MODEL", it can't be selected.
*
* If the "ALL" is selected and all of the indoor units were mixture of
"HEAT PUMP MODEL" and "COOLING ONLY MODEL", it can't be selected.
no
display
depend on
no setting
initial setting
* The setting temperature range depends on
the operation mode or the initial setting.
When the operating time is set, the
ex. The TIMER-1 is set 8:00 ON COOL 20
TIMER-1 TIMER-2
If the Timer Mode(DELETE) button is pressed during steps
the operating time for the selected day will be deleted.
If all the days are selected, the operating times for all of the day will be deleted.
(2) Even if the timer operation is set, the timer lamp of the
indoor unit does not light up.(The timer lamp is used for
wireless cemote controller only.)
05-12
OFF
* *
*
DRY FAN HEAT
HEAT only
TIMER-3 TIMER-4
4
6
to .
3 5
mark appears.
.
2 6
to .
or ,