Simple Remote Controller; Central Remote Controller - Fujitsu Airstage V series Service Manual

3. Simple remote controller

Stop the indoor and outdoor units. Push the remote controller
simultaneously for more than three seconds. The air conditioner will start to conduct a test
run and will display on the temperature display.
However the setting button does not have function but all other buttons,
displays and protection functions will operate.
To stop test running press the
For the operation method refer to the operating manual and perform operation check.
Check that there are no abnormal sounds or vibration sounds during test run operation.

4. Central remote controller

ACL
CLOCK
ADJUST
DAY TIME
TIMER TIMER
MODE
DELETE
TIMER DAY OFF TIMER
COPY SET
(1)
Push to select control mode from among Individual control mode / Group
control mode / All control.
(2) When Individual control mode is selected, use
ed central control number, then go to (3).
When Group control mode is selected use
then go to (3).
When All control mode is selected, go directly to (3).
(3)
Press TEST and
units.
SET
(4)
Press to send the signal and test run setting is sent to the indoor unit.
will flash as the signal is being transmitted.
60 minutes' test run starts.
To stop the test run,
It is possible to change the settings for the operation mode (heating / cooling) and fan setting.
will come on, then do the operation shown in (4). Test run will stop.
button of the simple remote controller.
(1) (2)
MEMORY CENTRAL
BACK
OPERATION CONTROL
SET
MEMORY GROUP
DELETE
SETTING SETTING
CHECK TEST
(4) (3)
SELECT
will light up. The operation setting is applied to the selected
do the operation shown in (3) above and press
button and
UTB-YCA / GCA
MASTER
CONTROL
FAN
TEMP .
ENERGY ANTI
CONTROL
ZONE
FREEZE
SAVE
FILTER
ON OFF
RESET
and to select the desir-
to select the desired group number,
ON OFF
01-05
UTB-YPB / GPB / TPB
button
.
SET