Rep 17 Engine Shield (Liu Pba, Smps) - Xerox WORKCENTRE PE 220 Service Manual

REP 17 Engine Shield (LIU
PBA, SMPS)
1. Before you remove the Engine Shield, you
should remove:
- Scan Assembly (Refer to
- Middle Cover (Refer to
2. Unplug all Connectors from the SMPS
and LIU PBA.
Figure 1
3. Remove six screws securing the Engine
Shield and release the Harness. Carefully
release the Engine Shield from the Actua-
tor Feed Sensor Lever.
Figure 2
Workcentre PE 220
REP 8)
REP 12)
11/05
4. If only removing the SMPS, remove the
Rear Cover (refer to
the Fuser Connector. Remove six screws
securing the SMPS. Unplug the Connec-
tor from the Main PBA and carefully
release the SMPS.
Figure 3
5. If only removing the LIU PBA, remove the
Rear Cover (refer to
two screws securing the LIU PBA. Unplug
the Connector from the Main PBA and
release the LIU PBA.
Figure 4
Repairs/Adjustments
REP 5) and unplug
REP 5) and remove
4-21