Repairs/Adjustments
REP 11 Platen Housing
1. Before you remove the Platen Housing,
you should remove:
- Scan Assembly (Refer to
- ADF Housing (Refer to
- OPE Unit (Refer to
2. Remove five screws from the Scan Upper
and remove it from the Scan Lower.
Figure 1
3. Take out the Battery.
Figure 2
4-12
REP
8)
REP
9)
REP
10)
4. Push the Holder in the direction of arrow
and remove the Belt, as shown below.
(The CIS will come out at the same time.)
5. Release the Belt and Flat Cable from the
CIS.
11/05
Figure 3
Figure 4
Workcentre PE 220