Configuring Snmpv3 Group Access Rights; Configuring Port Limit Controls - AMX NXA-ENET8-2POE Operation/Reference Manual

Configuring SNMPV3 Group Access Rights

Use the SNMPv3 Access Configuration page to assign portions of the MIB tree to which each SNMPv3 group
is granted access. You can assign more than one view to a group to specify access to different portions of the
MIB tree.
FIG. 49 SNMPv3 Access Configuration
SNMPv3 Access Configuration parameters
• Group Name
• Security Model
• Security Level
• Read View Name
• Write View Name
1.
Click Configuration, Security, Switch, SNMP, Access.
2.
Click Add New Access to create a new entry.
3.
Specify the group name, security settings, read view, and write view.
4.
Click Save.

Configuring Port Limit Controls

Use the Port Security Limit Control Configuration page to limit the number of users accessing a given port. A
user is identified by a MAC address and VLAN ID. If Limit Control is enabled on a port, the maximum
number of users on the port is restricted to the specified limit. If this number is exceeded, the switch makes the
specified response.
FIG. 50
Port Limit Control Configuration
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch
The name of the SNMP group. (Range: 1-32 characters, ASCII characters 33-126
only)
The user security model. (Options: any, v1, v2c, or the User-based Security Model
(usm); Default: any)
The security level assigned to the group:
NoAuth, NoPriv - There is no authentication or encryption used in SNMP
communications. (This is the default for SNMPv3.)
Auth, NoPriv - SNMP communications use authentication, but the data is not
encrypted.
Auth, Priv - SNMP communications use both authentication and encryption.
The configured view for read access. (Range: 1-32 characters, ASCII characters
33-126 only)
The configured view for write access. (Range: 1-32 characters, ASCII characters
33-126 only)
Configuring the NXA-ENET8-2POE
61