AMX NXA-ENET8-2POE Operation/Reference Manual page 85

Access Control List Configuration parameters (Cont.)
• ARP (Cont.)
• IPv4:
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch
IP/Ethernet Specifies whether frames can be matched according to their ARP/
Length RARP hardware address length (HLN) and protocol address
length (PLN) settings. (Options: Any - any value is allowed, 0 -
ARP/RARP frames where the HLN is equal to Ethernet (0x06) and
the (PLN) is equal to IPv4 (0x04) must not match this entry, 1 -
ARP/RARP frames where the HLN is equal to Ethernet (0x06) and
the (PLN) is equal to IPv4 (0x04) must match this entry; Default:
Any)
IP Specifies whether frames can be matched according to their ARP/
RARP hardware address space (HRD) settings. (Options: Any -
any value is allowed, 0 - ARP/RARP frames where the HRD is
equal to Ethernet (1) must not match this entry, 1 - ARP/RARP
frames where the HRD is equal to Ethernet (1) must match this
entry; Default: Any)
Ethernet Specifies whether frames can be matched according to their ARP/
RARP protocol address space (PRO) settings. (Options: Any - any
value is allowed, 0 - ARP/RARP frames where the PRO is equal to
IP (0x800) must not match this entry, 1 - ARP/RARP frames where
the PRO is equal to IP (0x800) must match this entry; Default:
Any)
MAC Parameters
DMAC Filter The type of destination MAC address. (Options: Any, MC - multi-
cast, BC - broadcast, UC - unicast; Default: Any)
IP Parameters
IP Protocol Filter Specifies the IP protocol to filter for this rule. (Options: Any, ICMP,
UDP, TCP, Other; Default: Any)
The following additional fields are displayed when these protocol filters are selected.
ICMP Parameters
ICMP Type Filter Specifies the type of ICMP packet to filter for this rule. (Options:
Any, Specific: 0-255; Default: Any)
ICMP Code Filter Specifies the ICMP code of an ICMP packet to filter for this rule.
(Options: Any, Specific (0-255); Default: Any)
UDP Parameters
Source Port Filter Specifies the UDP source filter for this rule. (Options: Any, Specific
(0-65535), Range (0-65535); Default: Any)
Dest. Port Filter Specifies the UDP destination filter for this rule. (Options: Any,
Specific (0-65535), Range (0-65535); Default: Any)
TCP Parameters
Source Port Filter Specifies the TCP source filter for this rule. (Options: Any, Specific
(0-65535), Range (0-65535); Default: Any)
Dest. Port Filter Specifies the TCP destination filter for this rule. (Options: Any,
Specific (0-65535), Range (0-65535); Default: Any)
TCP FIN Specifies the TCP No more data from sender (FIN) value for this
rule. (Options: Any - any value is allowed, 0 - TCP frames where
the FIN field is set must not match this entry, 1 - TCP frames
where the FIN field is set must match this entry; Default: Any)
TCP SYN Specifies the TCP Synchronize sequence numbers (SYN) value
for this rule. (Options: Any - any value is allowed, 0 - TCP frames
where the SYN field is set must not match this entry, 1 - TCP
frames where the SYN field is set must match this entry; Default:
Any)
Configuring the NXA-ENET8-2POE
75