Reset Button; Resetting To The Current Configuration; Resetting To Defaults; Rear Panel Components - AMX NXA-ENET8-2POE Operation/Reference Manual

Reset Button

If you encounter any malfunctions, such as a hang or nonrecoverable error, you might want to reset the
NXA-ENET8-2POE, via the Reset pushbutton on the front panel (FIG. 5):
FIG. 5 Reset Pushbutton

Resetting to the Current Configuration

To perform a reset using the existing configuration press the reset button for three seconds and release.

Resetting to Defaults

To reset the NXA-ENET8-2POE to its default configuration, by press and hold the reset button for more than
ten seconds and release.

Rear Panel Components

Power Supply Inlet

There is one power inlet on the rear panel of the NXA-ENET8-2POE (FIG. 6):
FIG. 6 Rear Panel - Power Supply Inlet
The standard power inlet is for the AC power cord.

Grounding Point

To prevent accidental electrical shock or damage to the NXA-ENET8-2POE, it is recommended that you
ground the unit to an earth point by attaching a grounding wire (not supplied) to the grounding point on the
rear panel, with a metal screw (FIG. 7).
FIG. 7 Rear Panel - Grounding Point
If located in a tall building, grounding points include metal drain pipes, and other
electrostatic conductive devices that lead to the ground, or if located on the first floor
of a building, the ground outside itself.
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch
NXA-ENET8-2POE
11