AMX NXA-ENET8-2POE Operation/Reference Manual page 84

Configuring the NXA-ENET8-2POE
Access Control List Configuration parameters (Cont.)
ACE CONFIGURATION
Ingress Port and Frame Type
• Ingress Port
• Frame Type
Filter Criteria Based on Selected Frame Type
• Ethernet
• ARP
74
Any port, port identifier, or policy. (Options: Any port, Port 1-10, Policy 1-8; Default:
Any)
The type of frame to match. (Options: Any, Ethernet, ARP, IPv4; Default: Any)
MAC Parameters
SMAC Filter The type of source MAC address. (Options: Any, Specific - user
defined; Default: Any)
DMAC Filter The type of destination MAC address. (Options: Any, MC - multi-
cast, BC - broadcast, UC - unicast, Specific - user defined;
Default: Any)
Ethernet Type Parameters
EtherType Filter This option can only be used to filter Ethernet II formatted packets.
(Options: Any, Specific (600-ffff hex); Default: Any)
A detailed listing of Ethernet protocol types can be found in RFC
1060. A few of the more common types include 0800 (IP), 0806
(ARP), 8137 (IPX).
MAC Parameters
SMAC Filter The type of source MAC address. (Options: Any, Specific - user
defined; Default: Any)
DMAC Filter The type of destination MAC address. (Options: Any, MC - multi-
cast, BC - broadcast, UC - unicast; Default: Any)
ARP Parameters
ARP/RARP Specifies the type of ARP packet. (Options: Any - no ARP/RARP
opcode flag is specified, ARP - frame must have ARP/ RARP
opcode set to ARP, RARP - frame must have ARP/RARP opcode
set to RARP, Other - frame has unknown ARP/RARP opcode flag;
Default: Any)
Request/Reply Specifies whether the packet is an ARP request, reply, or either
type. (Options: Any - no ARP/RARP opcode flag is specified,
Request - frame must have ARP Request or RARP Request
opcode flag set, Reply - frame must have ARP Reply or RARP
Reply opcode flag; Default: Any)
Sender IP Filter Specifies the sender's IP address. (Options: Any - no sender IP fil-
ter is specified, Host - specifies the sender IP address in the SIP
Address field, Network - specifies the sender IP address and
sender IP mask in the SIP Address and SIP Mask fields; Default:
Any)
Target IP Filter Specifies the destination IP address. (Options: Any - no target IP
filter is specified, Host - specifies the target IP address in the Tar-
get IP Address field, Network - specifies the target IP address and
target IP mask in the Target IP Address and Target IP Mask fields;
Default: Any)
ARP SMAC Specifies whether frames can be matched according to their
Match sender hardware address (SHA) field settings. (0ptions: Any - any
value is allowed, 0 - ARP frames where SHA is not equal to the
SMAC address, 1 - ARP frames where SHA is equal to the SMAC
address; Default: Any)
RARP DMAC Specifies whether frames can be matched according to their target
Match hardware address (THA) field settings. (Options: Any - any value
is allowed, 0 - RARP frames where THA is not equal to the DMAC
address, 1 - RARP frames where THA is equal to the DMAC
address; Default: Any)
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch