Command Usage - AMX NXA-ENET8-2POE Operation/Reference Manual

Users Configuration parameters
• User Name
• Password
• Password (again)
• Privilege Level

Command Usage




1.
Click Configuration, System, Switch, Users
2.
Click Add new user.
3.
Enter the user name, password, and privilege level.
4.
Click Save.
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch
The name of the user. (Maximum length: 8 characters; maximum number of
users: 16)
Specifies the user password. (Range: 0-8 characters plain text, case sensitive)
Re-type the string entered in the previous field to ensure no errors were made.
The switch will not change the password if these two fields do not match.
Specifies the user level. (Options: 1 - 15)
Access to specific functions are controlled through the Privilege Levels configura-
tion page (see Configuring User Privilege Levels section on page 50). The default
settings provide four access levels:
1 - Read access of port status and statistics.
5 - Read access of all system functions except for maintenance and debugging
10 - Read and write access of all system functions except for maintenance and
debugging
15 - Read and write access of all system functions including maintenance and
debugging.
The default guest name is "guest" with the password guest. The default administrator name is
"admin" with the password admin.
The guest only has read access for most configuration parameters. However, the administrator has
write access for all parameters governing the onboard agent. You should therefore assign a new
administrator password as soon as possible, and store it in a safe place.
The administrator has a privilege level of 15, with access to all process groups and full control over
the device. If the privilege level is set to any other value, the system will refer to each group
privilege level. The user's privilege should be same or greater than the group privilege level to have
the access of a group. By default, most of the group privilege levels are set to 5 which provides
read-only access and privilege level 10 which also provides read/write access. To perform system
maintenance (software upload, factory defaults, etc.) the user's privilege level should be set to 15.
Generally, the privilege level 15 can be used for an administrator account, privilege level 10 for a
standard user account, and privilege level 5 for a guest account.
Configuring the NXA-ENET8-2POE
49