Table of Contents
Advertisement
A Guide to TracVision S3
KVH offers an upgrade kit (KVH
Part #02-1026) that adds in-motion
tracking capability to the TracVision
S3, allowing you to receive satellite
signals while on the move.
4-4
4.1.8 Stationary Use Only
Your TracVision S3 antenna was designed for stationary use only.
As such, the antenna will track the desired satellite while your
vehicle is parked, but not while the vehicle is in motion.
4.2
IRD Troubleshooting
The IRD that was provided with your satellite television service
may also be the cause of less-than-ideal operation.
4.2.1 IRD Wiring
Refer to
Section 2.3.6, "Connecting the Antenna RF Signal Cable to
the IRD"
and your IRD user manual to confirm that the IRD is
properly connected to the Antenna Unit and the television.
4.2.2 IRD Faulty
In the case of a faulty IRD, refer to your IRD user manual for
service, replacement, and warranty information.
4.3
Antenna LNB Faults
Section 5, "Maintenance,"
authorized service personnel who may be required to replace the
TracVision S3 antenna LNB.
4.4
Computer Diagnostics
TracVision S3 has been designed to provide diagnostic readouts
on a personal computer having an RS-232 serial communication
port. If you are unable to isolate a system problem with the
foregoing troubleshooting tools, set up a laptop to carry out
computer diagnostics as described on the next page. System
problems will most likely be found somewhere through the
diagnostic readouts.
provides detailed instructions for
Advertisement
Table of Contents
Troubleshooting
