Pan And Tilt Camera - Old Camera Interface - Raymarine a Series Installation And Operation Instructions Manual

20.8 Pan and tilt camera — old camera interface
The thermal camera application menu options for a pan and tilt thermal camera with the old camera interface are shown below.
Activate Camera
Pause Image
Camera Home
Image Options
Adjust Contrast
Standby
Camera Set-up
Camera Set-up menu
Set Home Position
Camera menu
Align Camera
Note: The thermal camera menu options available are dependant on the software version of your multifunction display and
thermal camera. If options are different than listed above please refer to the manual that accompanied your thermal camera and /
or the installation and operations handbook which accompanied your multifunction display.
Note: It may be possible to update your camera to the new camera interface. Please contact your Raymarine dealer for details.
OSD menu options
Setup menus
The setup menus provide a range of tools and settings to
configure the thermal camera.
The menus can be accessed from any controller on the system.
The menus are overlaid onto the video image.
Note: The on-screen menus only appear on the thermal
camera image. They are not available when viewing the
visible light image (on dual payload models).
260
Brings the thermal camera out of standby mode. (only available when camera is in standby.)
• On
• Off (default)
Select to return the camera to its home position.
Select to display the Image Options sub-menu.
• Color
– Red
– Greyscale
– Glowbow
– Rainbow
– Fusion
• Scene
– Night Running
– Night Docking
– Day Running
– Man Overboard
• Thermal / Visible
• Reverse video
• Rear View
• Surveillance
Select to display the Adjust Contrast sub-menu.
• Contrast
• Brightness
• Color
Select to place the camera in to standby mode. (only available when camera is activated.)
Select to display the Camera Set-up menu.
• Set Home Position
• Camera menu — (Onscreen display (OSD) menu)
• Align Camera
Sets the camera's current position as the Camera Home position.
Provides access to the camera's onscreen display (OSD) menu options.
Enables changes to camera's horizontal alignment.
Menus available
Enable Point Mode
/ Disable Point
Mode
Video Setup
Set Symbology
User
Programmable
Button
Selecting Enable Point mode will turn point mode
on, selecting disable point mode will turn point
mode off. Only applies to models with mechanical
stabilization.
This menu is used to set the video configuration
options.
Settings associated with the status icons.
Configure the USER button on the JCU.
a Series / c Series / e Series