Display Power; New A Series Controls - Raymarine a Series Installation And Operation Instructions Manual

6.1 Display power

Powering the display on
1. Press the POWER button on the display.
2. Select Accept to acknowledge the disclaimer message.
Powering the display on
1. Press the POWER button.
2. Press the OK button to accept the disclaimer message.
Powering the display off
1. Press and hold the POWER button until the countdown
reaches zero.
Note: If the POWER button is released before the countdown
reaches zero, the power off is cancelled.
Standby (PowerSave) mode
In PowerSave mode all functions of the multifunction display
remain active, but the unit is placed into a low power state. The
LED lights around the Rotary controller will blink once every
1.5 seconds to indicate that the unit is in PowerSave mode.
PowerSave mode is cancelled by pressing a physical button or
when an alarm event occurs.
Note: To ensure user safety the PowerSave feature will not
be available if:
• any connected radars are switched on
• the multifunction display is providing autopilot control in a
system without a dedicated pilot head and the autopilot is
engaged.
Enabling PowerSave mode
To enable PowerSave mode follow the steps below.
1. Ensure any radars connected to the system are switched off.
2. Press the POWER button.
The shortcuts menu is displayed.
3. Select PowerSave Mode.
The multifunction displays is now in PowerSave mode.
4. You can wake the unit from PowerSave mode at anytime by
pressing a physical button on the multifunction display.
Note: PowerSave mode is automatically cancelled if an alarm
event occurs.
70

6.2 New a Series Controls

1
2
Description
1 Touchscreen
2 Power
3 Card reader
slot
D12367-1
Functions
Touch the screen to operate functions, including all
menu operations.
• Press once to switch the unit ON.
• Once powered on, press the Power button
again to adjust the brightness, perform a screen
capture, access Powersave mode or access the
power controls for external devices.
• Press and hold to switch the unit OFF.
• If an integrated pilot is engaged, press and hold
put the autopilot into STANDBY mode.
Open the card door to insert or remove a MicroSD
card. There is 1 card slot, used for electronic charts
and archiving waypoint, route, track and settings
data.
a Series / c Series / e Series
D12577-1