Enabling Ais; Displaying Ais Vectors - Raymarine a Series Installation And Operation Instructions Manual

14.4 Enabling AIS

Enabling AIS in the Chart application
To enable the AIS overlay in the Chart application follow the
steps below.
To enable the AIS overlay your system must include an AIS
receiver or transceiver. The AIS overlay is not available in 3D
view.
From the Chart application menu:
1. Select Presentation.
2. Select Overlays.
3. Select AIS: so that On is selected.
Selecting AIS: switches the AIS between On and Off.
For AIS information refer to
Enabling AIS in the radar application
From the radar application:
1. Select Menu.
2. Select Targets.
3. Select Display AIS Targets.
4. Select the relevant option from the list.
From the Display AIS Targets menu you can switch on
All AIS targets, only Dangerous AIS targets or switch AIS
targets Off.
134
Chapter 14 AIS function.

14.5 Displaying AIS vectors

You must have the correct data available before AIS vectors
can be displayed.
A target is defined as active when it has the following data
displayed graphically:
• A COG/SOG vector indicating the predicted distance that a
target will travel within a given period of time.
• A heading and direction of turn indicator.
Enabling and disabling AIS vectors
From the chart or radar application:
1. Select an AIS target.
The AIS target context menu is displayed.
2. Select AIS Vector.
Selecting AIS Vector will switch between On and Off.
Note: The same target vector and safe zone settings apply
to both radar MARPA and AIS targets.
a Series / c Series / e Series