Items Supplied With Unit; Gas Boiler - Buderus 800-24 Installation And Servicing Instructions

1.4

Items supplied with unit

Check the contents against the packing list to ensure that
nothing is missing.
Requirements to be met by the place of installation
NOTE
Observe all statutory building regulations
applying to the place of installation.
DANGER!
Inflammable materials or liquids must not be
stored or used near wall-mounted condensing
gas boilers. The site of installation must be
frost-protected.
1.5

Gas boiler

Remove the packing and discard to ensure proper recycling.
Do not remove the polystyrene foam bottom slab protecting the
connection nozzles. During installation the gas boiler and the
flue gas adapter must be protected to prevent site dirt from
entering, e.g. using aluminum foil.
NOTE!
Note the clearance required to install the flue
system (see chapter 1.8 "Flue installation").
Note the side wall minimum clearance of
100 mm. If a storage-type water heater is
installed underneath, take care that the
minimum clearances according to the installa-
tion instructions are adhered to.
Fit the wall bracket.
Removing the casing:
Open the cover of the control panel (fig. 5, item 1).
Remove the screw (fig. 5, item 2).
Open the locks (fig. 5, item 3) with the radiator key
(fig. 5, item 4).
Release the clasps (fig. 5, item 5).
Remove the boiler casing forwards (fig. 5, item 6).
Do not carry the casing by the clasps !
Combination unit type 800 - 24T25V / 29T25V:
Vertical boilers:
Pull forward the casing of the hot water reservoir and lift it
clear from the top holders. This is only possible with the
upper casing removed.
Attach the gas boiler to the wall bracket (fig. 6).
Subject to modifications resulting from technical improvements !
Installation and servicing instructions condensing gas boiler 800 - 24/29/43/60 and 800 - 24T25/29T25 H/V • edition 02/2006
5
fig. 4 Items supplied with unit
Key to fig. 4:
1: wall-mounted condensing gas boiler
2: wall bracket
3: technical documents
4: wall-mounting template
5: screw fittings for connecting the boiler (heating system)
gas service valve ½" (800-24/29/43)
gas service valve ¾" (800-60)
6
5
1
5
2
fig. 5 Removing the casing
fig. 6 Installation
Installation
2
1
3
4
6
5
4
Buderus • http://buderus-domestic.co.uk
1
3
11