Advanced Wireless Settings - D-Link DWR-112 User Manual

Section 3 - Configuration
Transmit
Set the transmit power of the antennas.
Power:
Beacons are packets sent by an Access Point to
Beacon Period:
synchronize a wireless network. Specify a value.
100 is the default setting and is recommended.
This value should remain at its default setting of
RTS Threshold:
2432. If inconsistent data flow is a problem, only
a minor modification should be made.
The fragmentation threshold, which is specified
Fragmentation:
in bytes, determines whether packets will be
fragmented. Packets exceeding the 2346 byte
setting will be fragmented before transmission.
2346 is the default setting.
DTIM Interval:
(Delivery Traffic Indication Message) 1 is the
default setting. A DTIM is a countdown informing
clients of the next window for listening to
broadcast and multicast messages.
Preamble
Select Short or Long Preamble. The preamble defines the length of the CRC block (Cyclic Redundancy Check is a common
Type:
technique for detecting data transmission errors) for communication between the wireless router and the roaming wireless
network adapters. Note: High network traffic areas should use the Short Preamble type.
Wireless Mode:
Use the drop-down menu to select the wireless modes you want to enable on the router. The available options are 802.11n
only, 802.11 Mixed(g/b), and 802.11 Mixed(n/g/b).
Band Width:
This setting can be used to adjust the bandwidth of the wireless signal. The default setting is 20/40 MHz (Auto).
Short Guard
Check this box to reduce the guard interval time therefore increasing the data capacity. However, it's less reliable and may
Interval:
create higher data loss.
D-Link DWR-112 User Manual

Advanced Wireless Settings

68