D-Link DWR-112 User Manual page 54

Section 3 - Configuration
Set Static IPv6 Address Connection
This mode is used when your ISP provides you with a set IPv6 addresses that does not change. The IPv6 information
is manually entered in your IPv6 configuration settings. You must enter the IPv6 address, Subnet Prefix Length, Default
Gateway, Primary DNS Server, and Secondary DNS Server. Your ISP provides you with all this information.
Use Link-Local
The Link-local address is used by nodes and routers when
Address:
communicating with neighboring nodes on the same link.
This mode enables IPv6-capable devices to communicate
with each other on the LAN side.
IPv6 Address:
Enter the WAN IPv6 address for the router here.
Subnet Prefix
Enter the WAN subnet prefix length value used here.
Length:
Default Gateway:
Enter the WAN default gateway IPv6 address used here.
Primary IPv6 DNS
Enter the WAN primary DNS Server address used here.
Address:
Secondary IPv6
Enter the WAN secondary DNS Server address used here.
DNS Address:
LAN IPv6
These are the settings of the LAN (Local Area Network) IPv6 interface for the router. The router's LAN IPv6 Address
Address:
configuration is based on the IPv6 Address and Subnet assigned by your ISP. (A subnet with prefix /64 is supported
in LAN.)
Click on the Next button to continue. Click on the Prev button to return to the previous page.
Click on the Cancel button to discard all the changes made and return to the main page.
D-Link DWR-112 User Manual 50