Advanced Wireless Settings - D-Link DIR-412 User Manual

Section 3 - Configuration
Transmit Power:
Set the transmit power of the antennas.
Beacon Period:
Beacons are packets sent by an Access Point to
synchronize a wireless network. Specify a value. 100
is the default setting and is recommended.
RTS Threshold:
This value should remain at its default setting of 2432.
If inconsistent data flow is a problem, only a minor
modification should be made.
Fragmentation:
The fragmentation threshold, which is specified in bytes,
determines whether packets will be fragmented. Packets
exceeding the 2346 byte setting will be fragmented
before transmission. 2346 is the default setting.
DTIM Interval:
(Delivery Traffic Indication Message) 1 is the default
setting. A DTIM is a countdown informing clients of the
next window for listening to broadcast and multicast
messages.
Preamble Type:
Select Short or Long Preamble. The preamble defines the length of the CRC block (Cyclic Redundancy Check is a common
technique for detecting data transmission errors) for communication between the wireless router and the roaming wireless
network adapters. Note: High network traffic areas should use the Short Preamble type.
Wireless Mode:
Use the drop-down menu to select the wireless modes you want to enable on the router. The available options are 802.11n
only, 802.11 Mixed(g/b), and 802.11 Mixed(n/g/b).
Band Width: This setting can be used to adjust the bandwidth of the wireless signal. The default setting is 20/40 MHz (Auto).
Short Guard Check this box to reduce the guard interval time therefore increasing the data capacity. However, it's less reliable and may
Interval:
create higher data loss.
D-Link DIR-412 User Manual

Advanced Wireless Settings

53