Table of Contents
Advertisement
Section 3 - Configuration
Transmit
Set the transmit power of the antennas.
Power:
Beacon
Beacons are packets sent by an Access Point to
Period:
synchronize a wireless network. Specify a value.
100 is the default setting and is recommended.
RTS
This value should remain at its default setting of
Threshold:
2432. If inconsistent data flow is a problem, only
a minor modification should be made.
Fragmentation:
The fragmentation threshold, which is specified
in bytes, determines whether packets will be
fragmented. Packets exceeding the 2346 byte
setting will be fragmented before transmission.
2346 is the default setting.
DTIM
(Delivery Traffic Indication Message) 1 is the
Interval:
default setting. A DTIM is a countdown informing
clients of the next window for listening to
broadcast and multicast messages.
Preamble
Select Short or Long Preamble. The preamble defines the length of the CRC block (Cyclic Redundancy Check is a common
Type:
technique for detecting data transmission errors) for communication between the wireless router and the roaming wireless
network adapters. Note: High network traffic areas should use the Short Preamble type.
CTS Mode:
Select None to disable this feature. Select Always to force the Router to require each wireless device on the network to
perform an RTS/CTS handshake before they are allowed to transmit data. Select Auto to allow the Router to decide when
RTS/CTS handshakes are necessary
Wireless
Use the drop-down menu to select the wireless modes you want to enable on the Router. The available options are 802.11n
Mode:
only, 802.11 Mixed (g/b), and 802.11 Mixed (n/g/b).
Bandwidth:
Use the drop-down menu to select 20MHz or 20/40MHz (Auto).
D-Link DIR-604 User Manual
Advanced Wireless Settings
61
Advertisement
Table of Contents
