Table of Contents
Advertisement
nd
2
# Disconnects session.
Output Name – library word configuration
To configure an output name using words from the word library (page 55) instead
of recording your own voice, replace steps 4 and 5 above with the following
steps.
Example: East side light
Up to eight library words can be strung together to achieve your desired phrase.
4.
Press [2], to configure a new zone name.
5
Select library word one, followed by # (e.g., East = word 58.)
Select library word two, followed by # (e.g., Side = word 125.)
Select library word three, followed by # (e.g., Light = word 95.)
Note:
If your system is configured with NX-181xx Voice keypads, you will be
prompted to either copy changed recordings or copy all recordings when exiting
this menu. Copy changed recordings, will only add the latest recordings whilst
selecting copy-all recordings will overwrite all recordings, new and old. Please
contact your security provider to verify how your system is configured.
For multiple recordings, press * once at step 6, which will take you back to step
4, this will allow additional recordings without exiting the system.
Room Name – Voice Recording
How to: Record a room name
To record a room name, and add this new recording to connected NX-
Step
Example
181xx Voice keypads.
1.
[PIN] Call the NX-595E via an offsite touch-tone phone to begin the session
Press [0] for system configuration menu
2.
Press [6] for voice message recording
Press [7] to record or configure a room name
Select a room number to record or configure, followed by #.
3.
(from 1~ 16)
4.
Press #, to record a new room name
5.
Record 3 second room name after the beep
st
1
nd
6.
2
# Disconnects session.
NX-595E User Manual
star, moves back to voice message recording menu.
star. Move back to step 4, (select a room number to record)
star, moves back to voice message recording menu
41
Advertisement
Table of Contents
