Care And Maintenance; Tyre Pressure; Wheel Replacement; Exterior Surfaces - Pride Mobility Pathrider 130 XL Owner's Manual

I X . C A R E A N D M A I N T E N A N C E
Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your
ability to perform the maintenance listed below, you may schedule inspection and maintenance at your
authorised Pride Provider. The following areas require periodic inspection and/or care and maintenance.

TYRE PRESSURE

If equipped with pneumatic tyres, always maintain the psi/bar/kPa air pressure rating indicated on
each tyre.
WARNING! It is important that the psi/bar/kPa air pressure rating indicated on each tyre
be maintained in pneumatic tyres at all times. Do not underinflate or overinflate your
tyres. Low pressure may result in loss of control, and overinflated tyres may burst. Fail-
ure to maintain the psi/bar/kPa air pressure rating indicated on the tyres at all times may
result in tyre and/or wheel failure.
Regularly inspect your scooter's tyres for signs of wear.

WHEEL REPLACEMENT

If your scooter is equipped with pneumatic tyres and you have a flat tyre, you can have the tube replaced. If your
scooter is equipped with a solid tyre insert, either the solid insert or the entire wheel must be replaced depending on
the model. Contact your authorised Pride Provider for information regarding replacement wheels for your scooter.
WARNING! Wheels on your scooter should only be serviced/replaced by an authorised
Pride Provider or qualified technician.
WARNING! Completely deflate pneumatic tyres before dismantling the rim or attempting repair.
WARNING! When changing a pneumatic tyre, remove only the lug nuts, then remove the
wheel. If any further disassembly is required, deflate the tyre completely or it may
explode.
Follow these easy steps for a quick and safe
repair for solid tyres:
1. Remove the key from the key switch.
2. Elevate the side of the scooter of which you are
removing the tyre. Place wooden blocks under
the frame to elevate the scooter.
3. Remove the lug nuts. See figure 24.
4. Pull the wheel off of the axle.
5. Slide the new wheel back onto the axle.
6. Reinstall the lug nuts and ensure they are tight-
ened properly.
7. Remove the blocks from beneath the scooter.

EXTERIOR SURFACES

Bumpers, tyres, and trim can benefit from an occa-
sional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or
vinyl conditioner on the scooter's
vinyl seat or tyre tread, as this may
cause them to become dangerously
slippery.
Pathrider 130 XL
LUG NUTS
Figure 24. Solid Tyre Wheel Removal
www.pridemobility.com
38