Care And Maintenance - Pride Mobility CELEBRITY DELUXE Manual

I X . C A R E A N D M A I N T E N A N C E
Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your
ability to perform the maintenance listed below, you may schedule inspection and maintenance at your
authorised Pride Provider. The following areas require periodic inspection and/or care and maintenance.
TYRE PRESSURE
„ If equipped with pneumatic tyres, always maintain a proper 2-2.4 bar (30-35 psi) tyre pressure.
WARNING! It is important that 2-2.4 bar (30-35 psi) tyre pressure be maintained in pneumatic tyres
at all times. Do not underinflate or overinflate your tyres. Low pressure may result in loss of control
and overinflated tyres may burst. Failure to maintain 2-2.4 bar (30-35 psi) tyre pressure in pneumatic
tyres at all times may result in tyre and/or wheel failure, causing serious personal injury and/or
damage to your scooter.
„ Regularly inspect your scooter's tyres for signs of wear.
WHEEL REPLACEMENT
If your scooter is equipped with pneumatic tyres and you have a flat tyre, you can have the tube
replaced. If your scooter is equipped with a solid tyre insert, either the solid insert or the entire wheel
must be replaced depending on model. Contact your authorised Pride Provider for information regarding
replacement wheels for your scooter.
WARNING! Prevent personal injury! Completely deflate pneumatic tyres before dismantling the rim
or attempting repair.
WARNING! When changing a tyre, remove only the centre lug nut, then remove the tyre. If any further
disassembly is required, deflate the tyre completely or it may explode, possibly resulting in personal injury.
EXTERIOR SURFACES
Bumpers, tyres, and trim can benefit from an occasional application of rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter's vinyl seat, floorboard, or tyre tread.
They will become dangerously slippery and result in personal injury and/or damage to your scooter.
CLEANING AND DISINFECTION
Precautions must be taken when cleaning medical equipment/devices to lower the risk of spreading
infection. This is to limit the spread of illness and other potentially infectious material (OPIM) (blood
components).
„ Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your
scooter. Avoid using products that may scratch the surface of your scooter.
„ If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for
use on your product before application.
How to Clean/Disinfect Equipment:
Hard/Soft Surfaces (Plastic shrouds, metal framing, seat fabric, tires, armrests and footplate mats, as
applicable)
● For hard/soft surfaces, remove visible contamination if present.
{ For plastic and metal use Lysol®/Clorox® disinfecting spray/wipes and other qualified SARS-
CoV-2 disinfecting products.
{ For other vinyl surfaces, clean with vinyl safe disinfecting wipes or solutions
„ Suggested Disinfectants
„ Birex® SE Disinfectant, Bleach-Rite® Disinfecting Spray, Citrace® Germicide
„ Dispatch® Spray Hospital Cleaner Disinfectant with Bleach
26