Cleaning And Disinfection; Battery Terminal Connections; Wiring Harnesses; Abs Plastic Shrouds - Pride Mobility Pathrider 130 XL Owner's Manual

I X . C A R E A N D M A I N T E N A N C E

CLEANING AND DISINFECTION

Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter.
Avoid using products that may scratch the surface of your scooter.
If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for
use on your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or
cleaning agent before applying it to your product. Failure to comply may result in skin
irritation or premature deterioration of upholstery and/or scooter finishes.

BATTERY TERMINAL CONNECTIONS

Make certain that the terminal connections remain tight and uncorroded.
The batteries must sit flat in the battery wells.
The battery terminals should face towards the inside of the scooter.

WIRING HARNESSES

Regularly check all wiring connections.
Regularly check all wiring insulation, including the charger power lead, for wear or damage.
Have your authorised Pride Provider repair or replace any damaged connector, connection, or insula-
tion that you find before using your scooter again.
PROHIBITED! Even though the scooter has passed the necessary testing requirements
for ingress of liquids, you should keep electrical connections away from sources of damp-
ness, including direct exposure to water or bodily fluids and incontinence. Check electri-
cal components frequently for signs of corrosion and replace as necessary.

ABS PLASTIC SHROUDS

The front tiller shroud, front shroud, and the rear shroud are formed from durable ABS plastic and are
coated with an advanced formula urethane paint.
A light application of car wax will help the shrouds retain their high gloss.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
These items are all prelubricated, sealed, and require no subsequent lubrication.
MOTOR BRUSHES
The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected periodi-
cally for wear by your authorised Pride Provider.
CONSOLE, CHARGER, AND REAR ELECTRONICS
Keep these areas free of moisture.
Allow these areas to dry thoroughly if they have been exposed to moisture before operating your
scooter again.
BRAKE PADS
The brake pads on your scooter should be inspected periodicly for wear. Once the pads reach 2mm or 1/8
th of an inch in thickness, they should be replaced. All brake pads should be replaced at the same time.
Contact your authorised Pride Provider for more information on replacing the brake pads.
Pathrider 130 XL www.pridemobility.com
39