Replacing Drive Motor, Motor Control Pcb, Power Supply - Astro Machine ASTROJET 2600P Service Manual

REPLACING DRIVE MOTOR, MOTOR CONTROL PCB AND CLUTCH
1. Remove operator right hand cover and non-operator
left hand cover.
2. Remove the four screws [A], two each side from the
rear cover plate and remove the rear cover plate.
3. Unplug the motor from the motor speed control and
then, remove the four Allen screws [B] that attach it
to the operator side-frame. Remove the drive belt,
and then remove the motor from the machine.
4. To remove the clutch, first disconnect the connector,
and then push out the pin [C]. Remove the bracket
screw [D] and pull the clutch off the shaft.
5. To remove the Motor Speed Control PC Board [2],
then disconnect the wires going to the board and
remove the two screws that attach the PC Board to the
base of the machine. Remove the PC Board.
6. To remove the Power Supply [3], then disconnect the
wires going to the board. Rest the machine on the
non-operator's side and remove the four screws that
attach the assembly to the base of the machine.
Remove the Power Supply
7. The sensor [1] can be accessed by removing the front
cover and then removing the two screws that attach it
to the base.
SECTION 5
DISASSEMBLY – ASSEMBLY
41