Astro Machine ASTROJET 2600P Service Manual page 38

SECTION 5
DISASSEMBLY – ASSEMBLY
3. Remove the feed roller access plate.
4. Rotate the feed roller shaft so that the
screws are face up and use a 3/32-inch
Allen wrench to remove the two button
head cap screws. This will permit you to
remove one half of the feed roller. Rotate
the shaft until the two screws holding the
second half of the feed roller in place are
accessible. Remove those screws also.
Install the feed roller half and replace the
screws. Rotate the shaft, replace the second
feed roller half, and fasten with the
remaining screws.
5. Replace the feed roller access plate and
fasten with the four Phillips screws.
34