Replacing Printheads And Transport Belts - Astro Machine ASTROJET 2600P Service Manual

SECTION 5
DISASSEMBLY – ASSEMBLY

REPLACING PRINTHEADS AND TRANSPORT BELTS

1. Remove both the Operator and Non-Operator side covers and
the Main Processor PC Board.
2. Remove top cover by removing the two screws that attach it to
the frame and the two springs.
3. Remove cover over printhead assembly by removing the two
Allen screws front and rear.
4. Remove the ribbon cable from each cartridge. Take care to
prevent damage to the ribbon cable or the connectors.
5. Remove the Allen screw holding the printhead assembly to the
bracket and remove the printhead assembly.
6. Repeat for the above steps for the remaining printhead
assemblies.
7. Remove the four screws [1] on each side that mount the side
guide assembly [2] and the sheet separator assembly [3] then,
lift out the assemblies.
38