Table of Contents
Advertisement
Service Disassembly Procedures
NOTE: The following disassembly should only be done by a qualified, trained service
representative.
CAUTION: When touching electronic boards wear a wrist strap that is grounded.
OPERATOR SIDE COVERS
1. Remove the three screws at the top of the left hand
operator side covers. Then remove the two screws
from the bottom of the cover.
2. Remove the cover. Do not pull it too far away as the
cable to the control panel could be damaged.
3. Disconnect the control panel cable from the PC Board.
Disconnect the connector from the Media Thickness
Control.
4. Reassemble in reverse order.
A is Head Transport Mechanism under Left Operator
Side cover.
See Carriage Assembly Timing Adjustment in Section 4-
Adjustments.
B is the Motor, Motor Drive Belt and Feed Clutch.
See Motor Drive Adjustment in Section 4 - Adjustments
SECTION 5
DISASSEMBLY – ASSEMBLY
35
Advertisement
Table of Contents
