Installing Power Modules; Installing Cards And Modules In The Chassis - Cisco ASR 9000 Series Installation Manual

Installing Cards and Modules in the Chassis

This chapter contains the procedures for installing cards and modules into the chassis after the chassis
has been installed into a rack. This chapter also describes how to connect cables to RSP, RP, alarm, and
line cards.
The procedures in this chapter for all Cisco ASR 9000 Series Routers are identical unless otherwise
Note
noted.
•
•
•
•
•
•
•
•

Installing Power Modules

The following procedures describe how to reinstall the power modules back into the chassis. Be sure to
follow the correct procedure for the type of power modules that you have.
Never force a power module into the power tray if you feel any resistance! The power modules are keyed
Caution
to prevent AC modules from being plugged into a DC power tray or a DC module into an AC power tray.
Forcing a module into the incorrect tray can cause damage to the module and the tray.
Installing Power Modules, page 3-1
Installing Fan Trays, page 3-4
Installing Cards in the Chassis, page 3-6
Connecting Line Card Network Interface Cables, page 3-17
Connecting Cables to the RSP or RP, page 3-22
Connecting the Alarm Cable, page 3-25
Connecting Power to the Router, page 3-26
Powering On the Router, page 3-31
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
3
C H A P T E R
3-1