Cisco ASR 9000 Series Installation Manual page 193

Chapter 3 Installing Cards and Modules in the Chassis
Figure 3-17
1 Console terminal
2 Modem
The ports labeled Ethernet, Console, and Auxiliary (AUX) are safety extra-low voltage (SELV) circuits.
Caution
SELV circuits should only be connected to other SELV circuits.
RSP/RP cables are not available from Cisco, but they are available from any commercial cable vendor.
Note
To comply with the intra-building lightning surge requirements of Telecordia GR-1089-CORE, Issue II,
Note
Revision 01, February 1999, you must use a shielded cable when connecting to the console, auxiliary,
and Ethernet ports. The shielded cable is terminated by shielded connectors on both ends, with the cable
shield material tied to both connectors.
RP Console and Auxiliary Port Connections
1
2
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
3
3 RJ-45 Ethernet cables
4 Console port
Connecting Cables to the RSP or RP
5 Auxiliary (AUX) port
4
5
3-23