Installing Base Chassis Accessories On The Cisco Asr 9912 Router - Cisco ASR 9000 Series Installation Manual

Installing Chassis Accessories
Figure 2-80
After the chassis has been installed in the rack and all chassis accessories have been attached, you can
install the fan trays, power supply modules, FC, RP, and line cards. See
Modules in the Chassis,"

Installing Base Chassis Accessories on the Cisco ASR 9912 Router

The base chassis accessories for the Cisco ASR 9912 Router include (see
•
•
Attach the honeycomb cosmetic cover to the front of the chassis above the cable management bracket by
Step 1
aligning the cover above the screw tabs on the chassis.
Attach the vented bezel cover by snapping it into place in front of the power system.
Step 2
Note
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
2-92
Optional Rear Exhaust Air Deflector on the Cisco ASR 9922 Router
for detailed installation instructions.
One honeycomb cosmetic cover
One vented bezel to cover the front of the power system
You will need to remove the vented bezel cover in order to install the power system. After the
power system is installed, you can re-install the vented bezel cover.
Chapter 2 Unpacking and Installing the Chassis
Chapter 3, "Installing Cards and
Figure 2-81):