Installing An Ac Or Dc Power Tray Into A Cisco Asr 9000 Series Router - Cisco ASR 9000 Series Installation Manual

Removing and Replacing Power System Components
Figure 5-14
1
1 Remove screws on each
Step 8 Rotate the ejector levers away from the tray to unseat the tray from its mating connector.
shows the process for the version 1 power trays, and
power trays.
Slide the power tray out of the bay of the chassis.
Step 9

Installing an AC or DC Power Tray into a Cisco ASR 9000 Series Router

Follow these steps to install an AC or DC power tray into the chassis:
Slide the power tray into the bay until it engages its mating connector on the chassis. The ejector levers
Step 1
will partly rotate inward as you do this.
Fully rotate the ejector levers inward to fully seat the power tray into its mating connector and seat the
Step 2
power tray mounting ears against the chassis mounting ears.
1 power trays and
fully seated, the captive screw in each ejector aligns with the screw hole in the power tray frame.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
5-22
Removing a Power Tray –Version 2 Power Tray (Cisco ASR 9010 Router Shown)
2
side that secure the power
tray to the chassis
Figure 5-16
Chapter 5
2 Loosen the captive screw in
each ejector lever
Figure 5-14
shows how to install the version 2 power trays. When the power tray is
Replacing Cisco ASR 9000 Series Router Components
3
3
Rotate the ejector levers out
to unseat the tray from its
mating connector
shows the process for the version 2
Figure 5-15 shows how to install the version
Figure 5-13