Wiper Arm Alignment - Chrysler 1998 Viper RT/10 Owner's Manual

S R
R E M O V A L A N D I N S T A L L A T I O N ( C o n t i n u e d )
938K-52
Fig. 18 Wiper Motor
A D J U S T M E N T S
WIPER ARM ALIGNMENT
The wiper arms/blades overlap. The driver's a r m /
blade must be above the passenger arm/blade i n the
park position.
(1) Put the wiper motor into the PARK position.
(2) The blades should be i n the blackout area. The
passenger blade should be approximately 22 m m (7/8
WINDSHIELD WIPERS AND WASHERS
8K - 9
inch) from top edge of the cowl t r i m panel to the cen-
ter pivot point of the blade (Fig. 19). The driver's
blade should be approximately 40 m m (1 9/16 inch)
from top edge of the cowl t r i m panel to the center
pivot point of the blade.
(3) The passenger's blade should not touch the
cowl t r i m panel.
(4) The driver's arm/blade should not touch the
passenger blade while going to the p a r k position.
(5) Operate the wipers, i f the requirements are not
met, check motor operation or module.
PANEL 938 K-6
Fig. 19 Windshield Wiper Arm Adjustment