Hoover U5063-930 Owner's Manual page 23

How to replace
Disconnect cleaner from electri-
cal outlet.
1. Place handle in operating
position and turn cleaner over so
bottom side is up.
2. To remove bottom plate, insert
end of flat screwdriver into wide
area of right-hand slot and push
handle of screwdriver to the rear.
Repeat in left-hand slot.
3. Lift extension of bottom plate,
rotate plate and remove from
cleaner body.
4. Remove agitator and broken
agitator belt.
(If belt is not broken but is stretched
or cut, proceed with steps 7-10 and
pull belt off motor pulley. Then
continue with step 5.)
5. Slip agitator through new belt
(with lettering toward outside of
cleaner) and position belt in belt
guide. Push end of belt into
opening in cleaner body.
Reposition agitator making sure to
align flat sides of projection on belt
end of agitator with flat sides of slot
in cleaner body.
6. Place the three tabs on bottom
plate into slots in front of cleaner
body. Snap bottom plate into place
over agitator.
21
.